When it comes to plumbing, there are a few key pieces of equipment that you need to know how to use. One of those pieces is the Y strainer. In this article, we’ll show you how to install a Y strainer in your plumbing system. So, if you’re looking for a way to improve your plumbing system, read on!
Turn off the sink’s water supply
Installing a new Y Stainer in your sink is a quick and easy way to update the look of your kitchen or bathroom. Plus, it’s a great way to prevent clogs and keep your drains flowing freely. But before you get started, there’s one important step you need to take: shutting off the water supply to your sink.
This will ensure that you don’t accidentally flood your sink while you’re working. Once the water is shut off, you can remove the old strainer and install the new one in its place. Then, simply turn the water back on and enjoy your newly updated sink! To find the best y strainer manufacturer in China, you should contact the best company.
Remove the old strainer by unscrewing it from the sink
To remove the old strainer, unscrew it from the sink. In the case of corroded or damaged strainers, it may be difficult to remove them. Using pliers or another tool may be necessary to loosen it. Once the old strainer is removed, clean out any debris that may have accumulated in the sink.
Clean the area around the sink hole and make sure it’s dry
When installing a Y strainer, clean the area around the sink hole and make sure it is dry. If there is any water or moisture on the surface, it could cause the strainer to slip and not seal properly.
Apply plumber’s putty around the edge of the sinkhole and press the new strainer into place
Once the strainer is in place, use a putty knife to push the strainer down into the sinkhole. Make sure the strainer is pushed all the way down so that the lip of the strainer is flush with the surface of the sink. Next, use a pencil to mark the location of the drain holes on the strainer. Use a drill to make pilot holes at these marks. Finally, use screws to secure the strainer in place.
Tighten screws on either side of the strainer until it’s secure
When installing a Y strainer, it’s important to tighten the screws on either side of the strainer until it’s secure. This will ensure that the strainer doesn’t come loose and cause any problems.
Check for leaks by turning the water supply on
Once the strainer is in place, turn on the water supply and check for any leaks. No leaks, then you’re good to go!
If you do notice any leaks, then it’s important to take care of them right away. Tighten the screws more if necessary, or use some plumbers’ putty to seal up any gaps.
Bottom line
Now that you have a basic understanding of what a Y strainer is and how it works, you can install one on your own property with confidence. Remember to take accurate measurements and follow the manufacturer’s instructions closely in order to ensure a proper installation. With a little elbow grease and these simple steps.
